Porsche Boxster 987 Oil Change

Using one of the REAR factory jack points. Jack up vehicle and place a jack stand under the front jack points.

Carefully position the jack stand to correctly contact that jack point of the vehicle

Repeat this procedure on opposite side of vehicle.

The Porsche Factory jack points are designed for pin top style jack pads. While a normal jack will work, the pin top ones are the safest to use and safest for the vehicle.

Using a low profile jack, center the jack directly in front of the engine and using chassis cross member, lift vehicle and place jack stands on rear jack points.

Photo #1 is 991 Cross Member

Photo #2 is 997.2 Cross Member

Photo 3 Shows a Cayman/Boxster rear jack point with optional jacking block.

Place a solid jack stand under the 4 jack points located near each respective wheel.

Oil Drain

Oil Filter Housing

Using 8mm Hex Socket, remove drain plug

Open Oil Filler in Trunk compartment to allow oil to drain faster.

Let oil drain for at least one hour.

Oil will be hot, use caution!

Use 14 Flute Oil Filter Cap Removal tool to loosen Plastic Filter Cap

Set a Ziploc bag on the oil filter cover once the oil filter cover is loose and take away the oil filter cover. This can reduce mess.

Note: the notch in the filter cover. Lift the O-ring with a pick or plier . This will allow you to stay away from any damage to the threading.

Install New Filter and Tighten Cap to 19 ft/lb

Reinstall and tighten drain plug to 37ft lb, It is crucial you use a new crush washer.

Cayman & Boxster Oil Filler Cap is located on right side of trunk.

Factory recommends 7.75L or Approximately 8.5 Qts of oil is required.

Lay towels around filler cap to prevent damage to interior.